Level-1 LRM Processing Chain
See S3 SRAL Algorithms Technical Baseline Document for further information about S3 Altimetry algorithms.
The main algorithms of the Level-1 LRM chain are:
This algorithm computes the surface type ("open ocean or semi-enclosed seas", "enclosed seas or lakes", "continental ice" or "land") determining the position of a "land-sea mask" Auxiliary Data File nearest to the geolocated measurement. The latitude and longitude resolution of this land-sea mask is 2 minutes.
This algorithm computes the USO correction from an Auxiliary Data File called "USO file" and this correction is applied to the tracker range. The "USO file" provides the real USO frequency drift measured on-board wrt the USO frequency nominal value. This algorithm also computes the tracker range rate converted into distance versus time.
This algorithm computes the internal path correction from an Auxiliary Data File called "CAL1 LTM file" and this correction is applied to the tracker range. The "CAL1 LTM file" provides the internal path delay measured on-board thanks to the CAL1 calibration mode, which measures the difference of travel between the transmission and the reference lines within the altimeter. This algorithm also computes and applies the instrumental delay correction measured on-ground, due to the distance between the duplexer and the antenna reference point.
This algorithm computes and applied the Doppler correction to the tracker ranges. The Doppler correction is a function of the emitted frequency, the pulse emitted duration, the orbit altitude rate, the emitted bandwidth and the sign of the slope of the transmitted chirp.
This algorithm computes the Automatic Gain Control (AGC) instrumental correction and applies this correction to the AGC. The AGC instrumental correction is computed taking into account the real gain value applied on-board and stored as a matrix table on an Auxiliary Data File called "characterisation file".
This algorithm computes the sigma0 scaling factor that is used at Level2 to determine the backscatter coefficients from the retracked amplitudes. The sigma0 scaling factor accounts for all power attenuations and gains, which has an impact on the signal received on-board.
On-board, there is a calibration mode called CAL2 that is able to compute the Gain Profile Range Window (GPRW) that provide the information of the attenuation of the samples of the waveforms available at Level-0 products due to several instrumental effects (e.g. intermediate frequency filters gain response). This algorithm corrects these Level-0 waveforms by the GPRW instrumental effects.